Specifications

5-13
COR Drop to Courtesy Beep Timer [*604*]
This timer determines the time between loss of COR and the generation of the courtesy
beep. This timer is programmable between 0.1 and 9.9 seconds. When initialize, this
timer will default to 1 second.
Courtesy Beep to PTT Drop Timer [*605*]
This timer determines the time between the generation of the courtesy beep and the
time the repeater transmitter turns off. This timer is programmable between 0.1 and
9.9 seconds. When initialize, this timer will default to 4 seconds.
DTMF Mute Delay Timer [*606*]
This timer determines the time the transmit audio will continue to be muted after the
entry of the last DTMF tone. This timer is programmable between 0.1 and 9.9 seconds.
When initialize, this timer will default to 1 second.
Repeater ID Timer [*607*]
This timer sets the time between transmissions of the repeater ID. The ID occurs when
a repeater user stops transmitting. This timer is programmable between 1.0 and 1799
seconds. When initialize, the timer defaults to 480 seconds.
Squelch Tail Message Timer [*608*]
This timer sets the time between transmissions of the squelch tail message. The
message occurs when a repeater user stops transmitting. This timer is programmable
between 1.0 and 1799 seconds. When initialize, the timer defaults to 1799 seconds.
Drop Out Message Timer [*609*]
This timer sets the time between transmissions of the drop out message. The message
occurs when a repeater stops transmitting. This timer is programmable between 1.0 and
1799 seconds. When initialize, the timer defaults to 1799 seconds.
Voice Delay Timer [*610*]
The CAT-1000B generates a PTT output and after a short delay the voice speaks. This
delay is field programmable. This feature is useful in repeater systems using CTCSS
tone squelch or multiple linking where the system is slow to come up. The voice delay
timer can be programmed between 0.1 and 9.9 seconds. When initialize, the timer
defaults to 1.0 seconds.
Autopatch Timer [*611*]
This timer sets the maximum length of an autopatch. This timer is programmable
between 1.0 and 1799 seconds. When initialize, this timer will default to 180
seconds.
Autopatch Activity Timer [*612*]
The repeater user must periodically key-up to maintain the autopatch. Five seconds
before the autopatch activity timer is to expire, the controller will generate a
warning beep. The user must key-up or the autopatch will disconnect. This timer is
programmable between 1.0 and 1799 seconds. When initialize, this timer will default
to 30 seconds.
DTMF Pre-window Timer [*613*]
This timer determines the time between the presence of COR and the point where the
DTMF window opens to accept DTMF entries. This timer is programmable between 0.1 and
9.9 seconds. When initialized, this timer will default to 1 second.
DTMF Window Timer [*614*]
This timer sets the length of time the window will remain open to accept DTMF entry.
This timer is programmable between 0.1 and 9.9 seconds. When initialized, this timer
will default to 8 second.