Specifications

5-18
Courtesy Tone Table
TONE FREQUENCY TABLE (Hertz)
0=OFF 1=500 2=600 3=700 4=800 5=900 6=1000 7=1100 8=1200
TONE DURATION - TONE SEPARATION TABLE (Milliseconds)
0=0 1=50 2=100 3=150 4=200 5=250 6=300 7=350 8=400 9=450
Erase Courtesy Tone Location (0-9)
Key-up and send [*93X]. Un-key and the voice will say: "POSITION X IS CLEAR"
Select Courtesy Tone
To select tone "163" as the repeater's courtesy beep, load Voice Message buffer #11
with "163." Example: Enter *3111 163. To select tone "167" as the remote base
courtesy beep, load Voice Message buffer #12 with "167". Enter *3112 167.
Westminster Chimes on Grandfather Clock
The Courtesy Tone generator can be used to generate Westminster chimes during the
Grandfather clock message announcement. Enter the following programming commands:
[*926 694*494*59]
[*927 299*294*59]
[*928 694*490*00]
[*3108 166 963 167 963 168 963 100]
Digital Voice Recorder
The CAT-1000B will support the DR-1000 Digital Voice Recorder for true voice message
announcements. Substitute DVR tracks for voice messages, speed dial identifications
and courtesy tones. For additional information on how to record tracks over the
telephone line, consult Chapter 11 of this manual.
Play Digital Voice Recorder Tracks (01-16)
Key-up and send [*94XX]. Un-key and the CAT-1000B will play the prerecorded message
stored at track "XX"
Record Digital Voice Recorder Tracks (01-16)
Key-up and send [*95XX]. Un-key and the voice will say: "START MESSAGE". Key-up and
enter the message to be stored at track "XX".
Erase Digital Voice Recorder Tracks (01-16)
Key-up and send [*96XX]. Un-key and the voice will say: "CONTROL OK".
Paging Tone Memory
The CAT-1000B will generate two-tone sequential paging tones. The first tone will be
on for one second while the second tone will be on for three seconds. Memory space is
provided for twenty paging tones. See the Two-Tone Sequential Paging Frequency Table.
Send Paging Tone Locations (01-20)
Key-up and send [*97XX]. Un-key and the CAT-1000B will send the paging tones stored
at that memory location. If the location is empty, the voice will say: "POSITION XX
IS CLEAR." During this send command, the length of each tone is increased to four
seconds to provide time to measure the frequency on a counter.