Specifications

11-1
Chapter 11 - Digital Voice Recorder
The DR-1000 provides true voice message announcements on your repeater system.
Substitute DVR tracks for voice messages, speed dial identifications and courtesy
tones. With four minutes of total record time, sixteen audio tracks provide
sufficient message capacity. Eight expanded user function switches are also included.
Connect the cable to the CAT-1000B at J6. Apply power to the controller.
DVR Control Selection
When the CAT-1000B is initialized, selection defaults to the DVR-1000. Make sure the
DVR-1000 is selected. Enter the programming mode, (unlock the controller) and use the
[*280] programming command. If necessary enter the [*281] programming command to
select the DVR-1000.
Format Digital Voice Recorder Memory
When power is first applied, format the DR-1000 memory. Memory is protected during
power failures. To format the DR-1000, press the Format switch SW1 located on the
board.
Signal Report Test
Key-up and send the DVR prefix code [725] followed by a [*]. Un-key and the voice
will say: "START TEST NOW." Key-up and record a seven second message. Un-key and the
test message will play back. You instantly know how your signal sounds through the
repeater.
J6
J1
J3
CAT-1000B
+12VDC
RECORD AUDIO OUT
DVR BUSY
CLOCK
DATA
GROUND
PLAY AUDIO IN
DR-1000
2
14
5
7
6
1
12
2
14
5
7
6
1
12
3
6
8
7
5
1
4
2 USER FUNCTION SWITCH #8
USER FUNCTION SWITCH #7
USER FUNCTION SWITCH #6
USER FUNCTION SWITCH #5
USER FUNCTION SWITCH #4
USER FUNCTION SWITCH #3
USER FUNCTION SWITCH #2
USER FUNCTION SWITCH #1