Specifications

1-4
Voice Synthesizer Messages (40) Maximum Word Length (31)
Digital Voice Recorder Tracks (16) Maximum Record Time (4 minutes)
Paging Tones (20) Two-Tone, One Second - Three Second
User Function Outputs (8) Switch 40VDC @ 60mA.
Hardware Inputs (8) 10K ohm input impedance
Audio Input Receiver 0.2 - 2VAC adjustable 10K ohms
Audio Output Transmitter 2VAC adjustable 600 ohms
Logic Inputs Low (0 to 0.8VDC) High (2.4 to 15VDC)
Logic Outputs Open Collector Relay Driver (60VDC at 80 mA)
Power 9 to 15VDC at 150 mA
Size 7.0" X 10.5"
Warranty Limited one year, parts and labor.
FCC Part 68 Equipment Registration
Should the CAT-1000B controller or its protective circuitry cause harm to the
telephone network, the telephone company shall, where practical, notify you that
temporary discontinuance of service may be required. However, where prior notices are
not practical, the telephone company may temporarily discontinue service if such
action is deemed reasonable in the circumstances. In the case of such temporary
discontinuance, the telephone company shall promptly notify you. You have the right
to bring a complaint to the FCC if you feel the disconnection is not warranted.
The telephone company may make changes in its communications facilities, equipment,
operation or procedures, where such action is reasonably required and proper in its
business. Should any such changes render the CAT-1000B incompatible with the
telephone company facilities you shall be given adequate notice to make modifications
to maintain service. The FCC prohibits the connection of the CAT-1000B controller to
party lines or to be used in conjunction with coin telephone service.
The CAT-1000B is equipped with a USOC RJ11C standard miniature modular jack and is
designed to have the telephone line connected with the standard plug. If the plug is
withdrawn, no interference to other equipment connect to the same line will be
encountered.
Telephone company notification prior to connection of the CAT-1000B controller is no
longer required. However, if requested by the telephone company you must provide the
registration number: (4H1USA-21626-KX-E), ringer equivalency number: (REN 0.4B) and
the line to which the CAT-1000B controller is connected.
In the event the CAT-1000B should fail to operate properly, disconnect it from the
telephone line until the controller is repaired. If service is needed contact:
Computer Automation Technology Inc.
4631 N.W. 31st. Avenue, Suite 142, Fort Lauderdale, Fl. 33309
Phone: VOICE [phone] - FAX [phone]
Internet: http:www.catauto.com
FCC Part 15 RF Interference
When installed in the RME-1000 rack mount enclosure, the CAT-1000B has been tested and
found to meet the standards for a Class A digital device, as specified in Part 15 of
the FCC Rules. These specifications are designed to provide reasonable protection
against such interference in a commercial installation. However, there is no
guarantee that interference will not occur in a particular installation.