User`s guide

30
User's Guide HDSPe MADI FX © RME
Options
EQ+D for Record
Switches EQ and Dynamics of all input channels into the recording path. In case Loopback has
been activated the EQ and Dynamics of the Output channel are within the recording path. See
also chapter 27.5.
Word Clock In Term.
Checking this option terminates
the word clock input internally
with 75 Ohms.
Mirror MADI1 Output to MADI2
and 3
This option provides a quick and
simple solution to mirror the first
MADI output to outputs 2 and 3.
The outputs are reduced to
2+2+64 channels (one MADI
port). All the data routed and
mixed to MADI port 1 is sent to
MADI port 2 and 3 as well.
Redundancy Mode
With redundancy mode active the
number of input channels is
reduced to 66 (AES plus one
MADI). The two other MADI ports
are used as fail safe inputs and
are used as soon as the signal on
the 'Current MADI Input' fails.
This setting is also a perfect
choice if the card is used as
single MADI I/O, saving
resources and providing simpler
channel selection dialogs.
Clock Mode
Sample Rate
Used to set the current sample rate. This is the same setting as in the Audio MIDI Setup, just
added here for your convenience.
Clock Source
The unit can be configured to use its own clock (Internal = Master), or one of the input signals
(Word, MADI, AES, Sync In). If the selected source isn't available (No Lock), the unit will
change to the next available one (this behaviour is called AutoSync). If none is available then
the internal clock is used. The current clock source is displayed as Current Clock.
Input Status
Displays the state of the current input signal:
• Clock state (No Lock, Lock, Sync)
• Sample rate (coarse)
• MADI Frame format (48K or 96K)
• Channel format (64 or 56 channels)