User's Manual

User’s Guide ADI-2 DAC v2.2 © RME
23
12.3 Subpage Bass / Treble
B/T Enable
OFF, ON. Default: ON
Bass Gain
Current Bass amplification for the current channels as set by encoder 1 (B). Adjustable between
-6 dB and +6 dB in steps of 0.5 dB.
Bass Freq
Corner frequency of the shelf bass filter. Adjustable from 20 Hz to 150 Hz in steps of 1 Hz. De-
fault: 85 Hz.
Bass Q
The quality factor of the filter is adjustable from 0.5 to 1.5.
Default 0.9.
Treble Gain
Current Treble amplification for the current channels as set
by encoder 2 (T). Adjustable between -6 dB and +6 dB in
steps of 0.5 dB.
Treble Freq
Corner frequency of the shelf treble filter. Adjustable from 3 kHz to 10 kHz in steps of 100 Hz.
Default: 6.5 kHz.
Treble Q
The quality factor of the filter is adjustable from 0.5 to 1.5. Default 0.7.
12.4 Subpage Loudness
Enable
ON, OFF. Default: OFF.
Bass Gain
Maximum Bass amplification. Adjustable between +1 dB
and +10 dB in steps of 0.5 dB. Default: +7 dB
Treble Gain
Maximum Treble amplification. Adjustable between +1 dB
and +10 dB in steps of 0.5 dB. Default: +7 dB
Low Vol Ref
Reference level for highest Bass/Treble amplification, referenced to the Volume set in dB.
Available range is -90 dB to -20 dB. Default: -30 dB. A volume setting below this point will have
maximum Bass/Treble gain, all volume settings above this point will have lower Bass/Treble
gain. 20 dB above the Low Vol Ref setting the Bass/Treble gain will be zero.
Note that changing the Ref Level will need a manual update of the Low Vol value. Loudness is
therefore most efficient in Auto Ref Level mode.