User Manual

User's Guide HDSP System HDSP 9652 © RME

Although the contents of this User’s Guide have been thoroughly checked for errors, RME can not guarantee that it is

correct throughout. RME does not accept responsibility for any misleading or incorrect information within this guide.

Lending or copying any part of the guide or the RME Driver CD, or any commercial exploitation of these media without

express written permission from RME Intelligent Audio Solutions is prohibited. RME reserves the right to change specifi-

cations at any time without notice.

CE / FCC Compliance

This device has been tested and found to comply with the limits of the European Council Directive on the

approximation of the laws of the member states relating to electromagnetic compatibility according to

RL89/336/EWG and RL73/23/EWG.

FCC

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant

to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses, and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause harmful interference to

radio communications. However, there is no guarantee that interference will not occur in a particular instal-

lation. If this equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the interference by

one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

RoHS

This product has been soldered lead-free and fulfils the requirements of the RoHS directive.

ISO 9001

This product has been manufactured under ISO 9001 quality management. The manufacturer, IMM Elek-

tronik GmbH, is also certified for ISO 14001 (Environment) and ISO 13485 (medical devices).

Note on Disposal

According to the guide line RL2002/96/EG (WEEE – Directive on Waste Electrical

and Electronic Equipment), valid for all european countries, this product has to be

recycled at the end of its lifetime.

In case a disposal of electronic waste is not possible, the recycling can also be

done by IMM Elektronik GmbH, the manufacturer of the HDSP MADI.

For this the device has to be sent free to the door to:

IMM Elektronik GmbH

Leipziger Straße 32

D-09648 Mittweida

Germany

Shipments not prepaid will be rejected and returned on the original sender's costs.