Datasheet
Radial Super Capacitor
RND is a trademark of Distrelec
Application
• Backup power: RAM, detonator, car recorder, smart meter, vacuum switch, digital camera, motor drive
• Energy storage: intelligent three meters, UPS, security equipment, communication equipment,
flashlights, water meters, gas meters, taillights, small appliances
• High current operation: electrified railway, smart grid control, hybrid vehicle, wireless transmission
• High-power support: wind power, locomotive start, ignition, electric cars, etc.
Standard test conditions:
The standard test conditions of this specification are standard atmospheric pressure, temperature 25 ° C,
relative humidity less than 60%.
Product structure
The monomer of this product is based on the principle of electric double layer capacitor. The internal use of activated carbon as the
positive and negative electrode, the electrolyte between the two electrodes is separated from the diaphragm, the aluminum shell
is sealed with the rubber plug, and the lead is on the same side of the product.
General specification
Rated discharge capacity(F 25℃) ΔV=2.16V-1.35V
12 F
Rated Voltage 2.7 V
Operating Temperature Min.
-40 °C
Operating Temperature Max. 70 °C
Maximum equivalent series resistance ESR (1KHz)
40 mΩ
Capacity tolerance
0~+30%
Performance index
Temperature characteristics
+70℃︱△
C/C︱
≤30%, ESR ≤ Initial value(25℃
)
-40
℃︱△
C/C
︱
≤30%
,
ESR ≤ 4 times initial value
(25
℃
)
High temperature without load
+70℃,after 1000±4h,︱△C/C︱≤30%,
ESR≤2 times the specified value
The steady state damp heat test
+40℃, 90--95%RH,240h,︱△C/C︱≤30%,
ESR≤4 times the specified value
Cycle life Expectancy
Adding rated voltage, normal temperature cycle charge and discharge test
500,000 times︱△C/C︱≤30%, ESR ≤4 times initial value(25℃)
High temperature load
+70℃ plus rated voltage, after 1000h,︱△C/C︱≤30%,
4 times the specified value
PART NUMBER
Example: RND 150HP-2R7-J126VYJ09
RND 150HP
2R7
J
09
126
J
V
Y
Series
Rated Voltage
Type
Capacitance Tolerance
Terminal
Shape
Internal Code
104 = 0.1 F
224 = 0.22 F
334 = 0.33 F
474 = 0.47 F
105 = 1F
155 = 1.5 F
205 = 2F
335 = 3.3 F
126 = 12 F
2R7 = 2.7 V
5R5 = 5.5 V
J = Radial
D = Coin
V = 0%-30%
U = -10%-20%
T = ±20%
Y = Leaded
N = Bolt Type
L = Stud Type
H = Horizontal
V = Vertical
C(J) = Cylindrical