Datasheet

Aluminium Electrolytic
Capacitors
NO. ITEM SPECIFICATION
2.6
Surge test
Rated surge voltage shall be applied (swich on) for 30 ± 5 seconds
and then shall be applied (swich off) with discharge for 5 ± 0.5 min at
room temperature . This cycle shall be repeated for 1000 cycles
2.7
Capacitance change : within
± 20% of the init
ial
specified
v
alue.
Dissi
pation
factor : lessthan
200% of the initial specified
value.
The maximum A.C.current having frequency of 100K Hz which ca
n be applied
to the capacitor at 105±2℃ continuously.Peak voltage not to exceed rated
D.
C.voltage.
Leakage current :
within initial specified value.
3. M
echanical characteristics:
NO. ITEM SPECIFICATION
3.1
Lead strength (A) Tensile strengt
h:
wire lead termina
l:
d (mm)
≦
0.45
0.5 ~ 0.8
0.8＜d≦1.25
load (Kg)
0.51
1.0 2.0
snap-in terminal:
d (mm)
load (Kg)
The capacitor shall withstand the constant tensile force specified
between the body and each lead for 10 seconds without damage
either mechanical or electrical.
(B) B
ending strength:
wire lead termina
l:
d (mm)
≦
0.45
0.5 ~ 0.8 0.8＜
d≦1.25
load (Kg)
0.25
0.51 1.0
snap-in terminal:
When the capacitance is
measured, there sha
ll
be
no intermittent c
ontacts,
or open- or short- circui-
ting.
There shall be no such
mechanical damage as
terminal damage etc.
With the capacitor in a vertical position appliy the load specified a
xially
to each lead . The capacitor shall b
e
rotated slowly from the
vertical to the horizontal position , back to the vertical position . The 90°
in the opposite direction and back the original position . Performance of
capacitor shall not have changed and leads shall be undamaged .
TEST METHOD
cross section area
of terminal
(m
㎡
)
force
(Kg)
TEST METHOD
snap-in terminal
2.0
APPLICABLE
RIPPLE
CURRENT
S＞1
1.0
2.5
0.5＜S≦
1
Distrelec Schweiz AG, Grabenstrasse 6, 8606 Nänikon, Switzerland, T [phone], [e-mail], distrelec.com