User Manual

20 21
RND 320-KEL SeriesRND 320-KEL Series
Remarks: During the operation, once press Esc and it will exit the mode.
If there are some wrong entering, you can rotate the knob. When the
complete value appears, enter again.
9.2TheRecallFunctionoftheBaeryTest
Note: Recall one group of the storage and use it.
Operation Description: Recall the rst group of storage and use it.
Remarks: Press ON/OFF to start and then the LED display on the le boom
is the running time and the LED display on the right boom is the
consumption of capacity.
10. OCP Test Function
Note: when the voltage reaches the VON value, it will delay for some time,
and the current outputs; at intervals, the step value will decrease
progressively until it reaches the cut-o current, or the voltage is higher
than that set by OCP, and then the output ends. Aer that, if the voltage is
higher than the OCP voltage and meanwhile the current value is between
the maximum and the minimum set currents, it passes; otherwise, it fails.
10.1 Function of OCP Test Seings
Note: It can set at most 10 groups of test parameters.