User Manual

26 27
RND 320-KEL SeriesRND 320-KEL Series
6
8
9
11
12
10
7
Enter the beginning power 20W by
pressing t he k nob o r but tons a nd
then press “ ” to enter the next
parameter settings.
Enter the step powe r 1W by pressin g
the knob or buttons and then press
“ ” to enter the next paramet er
settings .
Enter the step reduction time 1s by
pressing t he k nob o r but tons a nd
then press “ ” to enter the next
parameter settings.
Enter the ending p ower
10W b y
pressing t he k nob or
but tons a nd
then press “ ” to enter the next
parameter settings.
Enter the OPP voltage 8V by
pressing the knob or buttons and
then press “ ” to enter the next
parameter settings.
Enter the maximu m powe r 15W by
pressing t he k nob o r but tons a nd
then press “ ” to enter the next
parameter settings.
Enter the minimum powe r 10W by
pressing the knob or buttons and
then press “ ” to finish the
settings .
0.0000V 0.0000A
0V P0106
0.0000V 0.0000A
0V P0107
0.0000V 0.0000A
0V P0108
0.0000V 0.0000A
0V P0109
0.0000V 0.0000A
0V P0110
0.0000V 0.0000A
0V P0110
Return to the steady
stat e mode.
Remarks: During the operation, once press Esc and it will exit the mode.
If there are some wrong entering, you can rotate the knob.
When the complete value appears, enter again.
11.2 The Recall Function of OPP Test
Note: recall one group of storage and use it.
Operation Description: recall the rst group of
storage and use it.
Remarks: press ON/OFF to start and then the LED display on the
le boom is whether it passes or not; and that on the right boom is the
set power value at present.
12. External Trigger Function
Note: Press Shi+CR to switch the external trigger function. Through
the remote control, the steady state mode can be opened; the test
mode of the dynamic state, the sequence operation mode and the
baery test mode can be triggered.
Remarks: when LED GRAP on the display lights on, it can be triggered
externally. And here there is the memory function, that is, the
trigger will be saved.