Datasheet

ManualsBrandsRND Lab ManualsBanana Plugs & JacksBanana Socket ø4mm Blue 36A M6 Screw

Table Of Contents

4 mm Banana (female) Jack (socket)

RND is a trademark of Distrelec

Features

M6 threaded stud and hex nuts

Specification

Electrical protection

30 V AC/ 60V DC, 6 A

Operating Temperature

-20 ... 80 °C

Conformity

European Directive “RoHS” 2011/65/EU. European Directive 2015/863/EU

European regulation n°1907 / 2006 “REACH"

European regulation 2017 / 821 “Conflictminerals

Environment

“RoHS” compliant, Pb ≤ 4 %, Hg ≤ 0.1 %, Cr VI ≤ 0.1 %, Cd ≤ 0.01 %, PBB ≤ 0.1

%, PBDE ≤ 0.1 %, DEHP ≤ 0.1 %, BBP ≤ 0.1 %, DBP ≤ 0.1 %, and DIBP ≤ 0.1 %.

"REACH" compliant, no substances from the candidate list of SVHC for

authorisation at mass concentrations greater than 0.1 %.

Conductor Material Brass

The 4 mm banana

female connection

complies with the non-

shrouded 4 mm

banana plugs of the

worldwide most

famous manufacturers.

The terminal complies with axial

soldering of wire with lead-tin or

lead-free tin and 150 W maximum

soldering iron.

Ø10.2

Ø8

Ø3.5

The front insulator and

the rear insulating spacer

make the socket

compliant with conductive

panels because they

insulate the panel against

the metal parts of the

socket.

M6 x 0.75

Ø2 mm hole.

4.3

2.3

Ø10.2

Summary of content (2 pages)

PAGE 1
4 mm Banana (female) Jack (socket) Features M6 threaded stud and hex nuts Specification 30 V AC/ 60V DC, 6 A Electrical protection Operating Temperature Conductor Material -20 ... 80 °C Brass Conformity European Directive “RoHS” 2011/65/EU. European Directive 2015/863/EU European regulation n°1907 / 2006 “REACH" European regulation 2017 / 821 “Conflictminerals Environment “RoHS” compliant, Pb ≤ 4 %, Hg ≤ 0.1 %, Cr VI ≤ 0.1 %, Cd ≤ 0.01 %, PBB ≤ 0.1 %, PBDE ≤ 0.1 %, DEHP ≤ 0.1 %, BBP ≤ 0.1 %, DBP ≤ 0.
PAGE 2
4 mm Banana (female) Jack (socket) How to Implement Gather open-end spanners SW9 mm and SW8 mm, a panel with the specifications below, and a tool to drill the panel as below. Panel. Maxi. thickness : 4 mm. Pitch circle diameter to drill the panel : Ø8.0 (+0.1/-0) mm Drill the panel as above with the tool. If the nuts and the spacer are mounted on the socket then remove them. Push the socket into the hole of the panel as shown below. Panel. Front face of the panel. Spacer. Nuts. Rear face of the panel.