Datasheet

Banana (Female) Jack with
Solderless Screw Wire
Attachment
How to use, to attach a wire
Gather 3.5 mm and 2.5 mm flat-bladed screwdrivers, a stranded
or solid wire with the specifications below, and a tool to strip the
wire. Strip the end of the wire on 7 mm typically (6 mm at least).
If the plastic part is screwed on the metal part then unscrew it
and separate them.
With the screwdriver unscrew the screw without removing it.
Slip the stripped end of the wire into the hole of the metal
part and keep about 1 mm of the stripped length out of the
metal part as shown below.
With the 2.5 mm screwdriver screw and tighten (2.3.m maxi.
torque) the screw on the end of the wire.
Insert the metal part into the plastic part. Hold the plastic part,
insert the blade of the 3.5 mm screwdriver into the slot of the
metal part ; Screw until the metal part abuts against the plastic
part (2.3 N.m maxi. torque).
Strands.
Jacket(s).
Ø1.3 mm maxi.
1.00 mm² maxi.
(approximately AWG16).
Ø3.5 mm maxi..
7 mm typically (6 mm at least).
About 1 mm.
RND Part Nr.
RND 350-00139 Black
RND 350-00140
Red
Distrelec Schweiz AG, Grabenstrasse 6, 8606 Nänikon, Switzerland, T [phone], [e-mail], distrelec.com