Datasheet

ManualsBrandsRND Lab ManualsData & CommunicationsPC and Multimedia Cable Tester, LED

PC AND MULTIMEDIA CABLE TESTER

RND 365-00007

Amplier Probe

FEATURES

• The amplier Probe is designed to identify and trace wires or cables within a

group without damaging the insulation

• Works with any Tone Generator to identify wires.

• Volume control for increased sensitivity and adjustable to suit work

environment.

• Recessed ON/OFF buon prevents baery drain

• Power supply is in any 9V baery with a life of approximately 100 hours

• A plug receptacle is provided for head set or head phone

-1-

3-position

toggle switch

Phone jack

Tone Generator

3-colored LED

Red and black

test leads

4conductor

modular cord

and plug

Tip

Amplier Probe

Volume control

Test buon

Speaker

Summary of content (4 pages)

PAGE 1
PC AND MULTIMEDIA CABLE TESTER RND 365-00007 Amplifier Probe FEATURES • The amplifier Probe is designed to identify and trace wires or cables within a group without damaging the insulation • Works with any Tone Generator to identify wires. • Volume control for increased sensitivity and adjustable to suit work environment.
PAGE 2
INSTRUCTIONS: 1. Connecting the Tone generator. In terminated working cables: Connect one test lead to a terminated wire and other test lead to earth or equipment ground. In unterminated or non-working cables: Connect one test lead to a terminated wire and other test lead to earth or equipment ground. 2. Depress the round on/off spring-loaded button of the amplifier probe. The volume control switch can be adjusted to suit the environment.
PAGE 3
INSTRUCTIONS: • IDENTIFYING TIP & RING (SWITCH TO “OFF”): 1. Connect the RED test lead to the side of the one line and the BLACK lead to the side of the another line. 2. The LED will glow “GREEN” when you connect the RED test lead to the RING SIDE of the line. 3. The LED will glow “RED” when you connect the RED test lead to the TIP SIDE of the line. • IDENTIFYING LINE CONDITION (SWTICH TO “OFF): 1. Connect the RED test lead to the RING SIDE of the line and the BLACK to the TIP. 2.
PAGE 4
• TESTING CONTINUITY USING TONE (SWITCH TO “TONE”): (CAUTION: DO NOT CONNECT TO AN ACTIVE AC CIRCUIT EXCEEDING 24V IN THIS MODE.) 1. Connect the test leads to the subject pair. 2. Use a handset or headset at the remote end and touch the wire end(s) with the clip leads(s) 3. Reception of tone is an indication of continuity • MODULAR TESTING: 1. All above tests are available through the modular plug for line 1 only - red and green wires. • COAX TESTING: 1.