Datasheet

USB Powered Soldering Iron
Art. Nr.
RND 560-00242
RND is a trademark of Distrelec
Features
• Small and compact for portability
• Rapid heat up and instant recovery
• Long life tip with a protective cap
Specification
Input
USB 5 V
Power 8 W
Heating Time < 15 seconds
Cooling Time
< 30 seconds
Highest Heating Temperature 380 ... 400 °C
Accessories
1. When you touch the “touch switch” on the pen, the red LED indicator will light up. It will heat up and 15 seconds later, it is ready
for soldering work.
2. When you release "touch switch", the pen will get into sleep mode after the red indicator goes out.
3. When you re-touch the “touch switch”, the red LED indicator will light up again. It will get re-started.
4. When the "touch switch" can`t activate the pen, the red LED indicator will also light up if you slightly shake it. Then it will heat up
and be ready for soldering work again.
How to Solder:
Option 1: Connect USB Socket with your laptop
Option 2: Connect USB Socket with your cell phone or power bank
1. When under this connection way, the "touch switch" will not work. Instead, the
"vibration switch" inside the pen will start working.
2. After connecting, the red LED indicator will light up, please hold the pen and wait for
about 15 seconds, the pen will get heated up and ready for soldering work.
3. The LED light will go off and the pen will get into sleep mode automatically then it is idle
for 25 seconds.
4. When you pick up the pen, the pen will start working again.