Datasheet

ESD Bench Mat 2 Layer

– Smooth Finish

Description

Great value ESD bench matting made from anti-static

(conductive) and static dissipative materials with synthetic

rubber. Suitable for use in workshops or laboratories for

microelectronic industries.

Features

• 2mm thick double-layer structure

• Surface layer is a 0.5mm thick static-dissipative layer

• Bottom layer is a 1.5mm conductive layer

• Available in blue, grey or green

Colours / FinishConstruction

600mm

1200mm

TOP RIGHT

BOTTOM RIGHT

TOP LEFT

BOTTOM LEFT

Fig 1: Stud Positioning (Stud Size: 10mm)

RND is a trademark of Distrelec

PAGE 1
ESD Bench Mat 2 Layer – Smooth Finish Description Great value ESD bench matting made from anti-static (conductive) and static dissipative materials with synthetic rubber. Suitable for use in workshops or laboratories for microelectronic industries. Features • 2mm thick double-layer structure • Surface layer is a 0.5mm thick static-dissipative layer • Bottom layer is a 1.
PAGE 2
ESD Bench Mat 2 Layer – Smooth Finish Grounding Sufficient ground cords should be used to reliably meet EN 61340-5-1 Table 3 less than 1 x 109 ohms for working surfaces. Industry recommendation is that continuous runs of ESD matting should be grounded at 10ft intervals to allow proper charge decay rates. Each individual ESD mat should be grounded with ground snaps located no further than five feet from either end.