Datasheet

ManualsBrandsRND Power ManualsAAAPrimary Battery, Alkaline, AAA, 1.5V, Ultra Power, Pack of 48 pieces

1. Scope:

This specification is applicable to RND 305-00001.

2. Law & Regulation Compliances:

This product complies with EU’s battery directive (2013/56/EU).

Packaging materials comply with EU’s directive on packaging materials and waste (94/62/EC)

3. General:

3.1 Type designation

IEC/ JIS LR03

ANSI 24A

Common AAA

3.2 Chemical system: Zn/KOH-H

O/MnO

3.3 Nominal voltage: 1.5 V

3.4 Weight: Approximate 11.5g

3.5 Dimension (mm)

The dimensions shall be in accordance with the below figures both prior to and after service output test.

Measuring equipment shall be with an accuracy ±0.05mm at least.

min

max

9.9

10.4

43.8

44.5

4.3

3.8

0.8

3.6 Capacity: Approximate 1300mAh (10mA, 24h/d, 20℃, e.v.= 0.8V)

3.7 Operation temperature : -18℃~50℃

Recommend storage temperature : Not exceed 30℃

3.8 Heavy Metal Contents: Hg ≤1 ppm, Cd≤20ppm, Pb≤40ppm

Primary Alkaline Battery

1.5 V LR03/AAA Pack of 48 pieces

Distrelec Schweiz AG, Grabenstrasse 6, 8606 Nänikon, Switzerland, T +41 44 944 99 11, info@distrelec.com, distrelec.com

Summary of content (6 pages)

PAGE 1
Primary Alkaline Battery 1.5 V LR03/AAA Pack of 48 pieces 1. Scope: This specification is applicable to RND 305-00001. 2. Law & Regulation Compliances: This product complies with EU’s battery directive (2013/56/EU). Packaging materials comply with EU’s directive on packaging materials and waste (94/62/EC) 3. General: 3.1 Type designation IEC/ JIS ANSI Common LR03 24A AAA 3.2 Chemical system: Zn/KOH-H2O/MnO2 3.3 Nominal voltage: 1.5 V 3.4 Weight: Approximate 11.5g 3.
PAGE 2
4. Electrical Characteristics Unless otherwise stated, all measurements are to be performed at a Standard Environment of 20 ± 2°C 55 ± 20% RH. All samples are normalized for 8 hours at least at the above environment prior to measurement. The digital voltmeter (DCM) is with the precision of 1mV (internal resistance not less than 1 Megohm). The load resistance of the total circuit is accurate within ±0.5% of the specified value. 4.1 Open circuit voltage and closed circuit voltage (Load resistance 3.9Ω, 0.
PAGE 3
5. Leakage Resistance 5.1 Over discharge leakage test Test conditions: 20±2℃ & RH 55±20%, 20Ω continuous discharge 48h. Number of test samples: 9 batteries Requirement: No visible leakage; No explosion. 5.2 High temperature leakage test Test conditions: store 20 days under 60±2℃, then store 4~24h under standard environment. Number of test samples: 24 batteries Requirement: No visible leakage; No explosion. 6. Security Characteristics 6.
PAGE 4
9. Packaging Requirements 9.1 The total of heavy metal lead, cadmium, mercury, and hexavalent chromium concentration shall not exceed 100 ppm in Packaging materials and printing inks. Ozone depleting substances (ODS) shall not be used in the manufacturing of any packaging. The printing on each cell label is legible and permanent. Label defects, if any, shall conform to mutually agreed upon limit samples. 9.
PAGE 5
Distrelec Schweiz AG, Grabenstrasse 6, 8606 Nänikon, Switzerland, T +41 44 944 99 11, info@distrelec.com, distrelec.
PAGE 6
10. Components / Information on Ingredients: Chemical Nature: MATERIALS Manganese Dioxide (MnO2) Zinc Powder (Zn) Alkaline zinc-manganese dioxide batteries APPROXIMATE PERCENT OF CAS NO. MATERIALS TOTAL WEIGHT (%) APPROXIMATE PERCENT OF TOTAL WEIGHT (%) CAS NO. ~42.0 1313-13-9 Brass ~3.0 12597-71-6 ~14.5 7440-66-6 Fe ~22.0 7439-89-6 Water (H2O) ~8.0 7732-18-5 Ni-plating ~0.3 7440-02-0 Potassium Hydroxide (KOH) ~5.0 1310-58-3 Bi ~0.004 7440-69-9 Carbon ~2.5 7782-42-5 In ~0.