Datasheet

ManualsBrandsRND Power ManualsBatteries and ChargersPrimary Battery, Alkaline, C, 1.5V, Ultra Power, Pack of 10 pieces

1. Scope:

This specification is applicable to RND 305-00005.

2. Law & Regulation Compliances:

This product complies with EU’s battery directive (2013/56/EU).

Packaging materials comply with EU’s directive on packaging materials and waste (94/62/EC)

3. General:

3.1 Type designation

IEC/ JIS LR14

ANSI 14A

Common C

3.2 Chemical system: Zn/KOH-H

O/MnO

3.3 Nominal voltage: 1.5 V

3.4 Weight: Approximate 68 g

3.5 Dimension (mm)

The dimensions shall be in accordance with the below figures both prior to and after service output test.

Measuring equipment shall be with an accuracy ±0.05mm at least.

min

max

25.0

26.0

49.0

50.0

13.0

7.5

1.5

3.6 Capacity: Approximate 7500mAh (25mA, 24h/d, 20℃, e.v.= 0.8V)

3.7 Operation temperature : -18℃~50℃

Recommend storage temperature : Not exceed 30℃

3.8 Heavy Metal Contents: Hg ≤1 ppm, Cd≤20ppm, Pb≤40ppm

Primary Alkaline Battery

1.5 V LR14/C Pack of 10 pieces

Distrelec Schweiz AG, Grabenstrasse 6, 8606 Nänikon, Switzerland, T +41 44 944 99 11, info@distrelec.com, distrelec.com

Summary of content (6 pages)

PAGE 1
Primary Alkaline Battery 1.5 V LR14/C Pack of 10 pieces 1. Scope: This specification is applicable to RND 305-00005. 2. Law & Regulation Compliances: This product complies with EU’s battery directive (2013/56/EU). Packaging materials comply with EU’s directive on packaging materials and waste (94/62/EC) 3. General: 3.1 Type designation IEC/ JIS ANSI Common LR14 14A C 3.2 Chemical system: Zn/KOH-H2O/MnO2 3.3 Nominal voltage: 1.5 V 3.4 Weight: Approximate 68 g 3.
PAGE 2
4. Electrical Characteristics Unless otherwise stated, all measurements are to be performed at a Standard Environment of 20 ± 2°C 55 ± 20% RH. All samples are normalized for 8 hours at least at the above environment prior to measurement. The digital voltmeter (DCM) is with the precision of 1mV (internal resistance not less than 1 Megohm). The load resistance of the total circuit is accurate within ±0.5% of the specified value. 4.1 Open circuit voltage and closed circuit voltage (Load resistance 1.0Ω, 0.
PAGE 3
) MAD：minimum average duration--our guarantee discharge value. 4)Normal：normal data, it's our normal daily value, battereis dicharge value are on this as base to be upper or lower. 5. Leakage Resistance 5.1 Over discharge leakage test Test conditions: 20±2℃ & RH 55±20%, 3.9Ω continuous discharge 48h. Number of test samples: 9 batteries Requirement: No visible leakage; No explosion. 5.2 High temperature leakage test Test conditions: store 20 days under 60±2℃, then store 4~24h under standard environment.
PAGE 4
8. Expiry Date Marking: 8.1 Unless otherwise specified, each battery will carry a manufacturing date code followed by month and year of manufacturing for domestic and manufacturing date code followed by month and year of expiry for export. (Shelf life 5 years) 9. Packaging Requirements 9.1 The total of heavy metal lead, cadmium, mercury, and hexavalent chromium concentration shall not exceed 100 ppm in Packaging materials and printing inks.
PAGE 5
Distrelec Schweiz AG, Grabenstrasse 6, 8606 Nänikon, Switzerland, T +41 44 944 99 11, info@distrelec.com, distrelec.
PAGE 6
10. Component / Information of Ingredients Chemical Nature: MATERIALS Manganese Dioxide (MnO2) Zinc Powder (Zn) Alkaline zinc-manganese dioxide batteries APPROXIMATE PERCENT OF CAS NO. MATERIALS TOTAL WEIGHT (%) APPROXIMATE PERCENT OF TOTAL WEIGHT (%) CAS NO. ~41.0 1313-13-9 Brass ~1.35 12597-71-6 ~17.5 7440-66-6 Fe ~15.0 7439-89-6 Water (H2O) ~10.0 7732-18-5 Ni-plating ~0.18 7440-02-0 Potassium Hydroxide (KOH) ~8.0 1310-58-3 Bi ~0.005 7440-69-9 Carbon ~2.5 7782-42-5 In ~0.