User Manual
2
RND 305-00016 & 305-00017
Keep this manual in a safe place for quick reference at all times.
This manual contains important safety and operation instructions for correct use of the ba ery charger. Read through the manual
and pay special a ention to the markings and labels of the charger, ba ery and
equipment connected to the ba ery system.
Pay special a ention to these two types of notices used in this manual.
WARNING:
Failure to heed this warning may cause injury to persons and damage to Equipment.
CAUTION:
Failure to observe this warning may result in damage to equipment and improper
functioning of the Charger.
WARNING:
• The charger is designed for in-door use. Protect the charger from ingress of water.
• This charger is made to charge only properly sized lead acid ba eries.
• Charging other types of ba ery or under-sized lead acid ba eries may cause fi re or explosion.
• Install the charger in accordance with all local codes
• Do not use the charger if it has been dropped or damaged.
• Do not remove casing of the charger, there is no user –serviceable parts inside.
• Do not charge the ba ery on boats. Remove the ba ery and charge on shore.
• Never a empt to charge a frozen ba ery
• Never a empt to charge a damaged ba ery.
• Wear protective goggles and turn your face away when connecting or disconnecting the ba ery.
• Never place the charger on top of a ba ery.
• Never smoke, use an open fl ame, or create sparks near ba ery or charger during normal charging
operation as ba eries may give out explosive gas.
• Do not charge ba eries in an enclosure (box- in) due to possible explosion of entrapped explosive gas.
• Use of accessory not recommended may cause risk of fi re, electric shock.
• Disconnect the mains supply before connecting or disconnecting the links to the ba ery.
• If the charger does not work properly or if it has been damaged, unplug its AC and DC connection.
CAUTIONS:
• Refer to ba ery manufacturer’s specifi c recommended values for ba ery type se ings and fl oat voltage se ing.
• Fix the charger to a stable surface using the holes at the fl ange.
• Ensure all ventilation ports are not obstructed for effi cient fan cooling, keep loose so material or paper off at the bo om of the
charger.
• If longer output charging cord is required, make sure the diameter is adequate for the current in given cable length.