RND 305-00019 USER MANUAL – BEDIENUNGSANLEITUNG Smart Charger RND 305-00019 1
RND 305-00019 Introduction The RND 305-00019 is a Switch Mode Battery Charger with MCU controlled charging. Maximum charge is achieved through 4 stage charging (Precondition, Bulk, Absorption and Float charge stages). This charger is suitable for 5AH-120AH 12V lead acid batteries including GEL and AGM. Another excellent feature is a sealed splash and dust proof IP-55 rated polycarbonate casing. !Please read this manual carefully and follow the instructions! ENGLISH Features 1.
RND 305-00019 Warning: • This charger is designed for only charging 12V lead acid batteries of 5 to 120Ah. • Do not use this charger for any other purpose • For indoor use only • Explosion hazard: A battery being charged could emit explosive gases. • Avoid smoking or open sparks or naked flames in the vicinity of the battery. • Do not cover the charger while charging, allow good ventilation to the charger. • Danger of chemical burns: battery acid is highly corrosive.
RND 305-00019 Plug in the charger to AC mains (100 - 240V) wall socket. The indicatiors light up one by one as charger goes through a series of self checks. Then all lights are on together and off to indicate the end of checks except the operation “Standby” indicator. Connect the red output lead to the positive terminal of the battery and the black lead to the negative teminal. Select the appropiate Charge Mode by pressing the Mode button one or more times within 2 minutes.
RND 305-00019 Check Mode and Normal Charging The Charger first checks the battery’s condition, for normal battery this indication extinguishes after a few seconds and charger enters into “Charge Mode” and finally to the “Float/maintenance Mode” when the battery is fully charged . Charging Stages Bulk: This charges the battery up to about 80% full. The charger delivers max 5A current for Car and Low temperature mode, 1.5A for Motor Bike Mode until the battery voltage rises to a set value.
RND 305-00019 Specifications 100 - 240 V~, 50/60 Hz, 1.5 A max. Maximum Output Charging Current 5A Max. Power 70 W Efficiency >78 % Maximum Output Charging Current for Car / Low Temp. Mode 5A Absorption Voltage (Motor Cycle / Car Mode) 14.4 V Absorption Voltage (Low Temperature Mode) 14.
RND 305-00019 USER MANUAL – BEDIENUNGSANLEITUNG Intelligentes Ladegerät RND 305-00019 7
RND 305-00019 Einleitung Beim RND 305-00019 handelt es sich um ein Schaltladegerät mit MCU-gesteuertem Laden. Die maximale Ladung wird durch 4-phasiges Laden (Vorkonditionierungs-, Volllast-, Absorptions- und Erhaltungsphase) erreicht. Dieses Ladegerät ist für 12-V-Bleisäurebatterien einschliesslich GEL und AGM mit einer Kapazität von 5 Ah bis 120 Ah geeignet. Ein weiteres hervorragendes Merkmal ist das verschlossene, spritzwassergeschützte und staubdichte Polycarbonatgehäuse der Schutzart IP-55.
RND 305-00019 • Dieses Ladegerät ist ausschliesslich zum Laden von 12-V-Bleisäurebatterien mit einer Kapazität von 5 Ah bis 120 Ah ausgelegt. • Verwenden Sie dieses Ladegerät zu keinen anderen Zwecken. • Nur für den Einsatz in Innenräumen geeignet. • Explosionsgefahr: Eine Batterie, die geladen wird, kann explosive Gase freisetzen. • In der Nähe der Batterie darf nicht geraucht werden, offene Flammen sind fernzuhalten, und Funkenschlag ist zu vermeiden.
RND 305-00019 Schliessen Sie das Ladegerät an eine Netzsteckdose (100 - 240 V) an. Die Anzeigen leuchten nacheinander auf, während das Ladegerät eine Reihe von Selbsttests durchläuft . Anschliessend leuchten alle Anzeigen ausser der Betriebsbereitschaftsanzeige STANDBY gleichzeitig auf, um den Abschluss der Tests zu kennzeichnen. Schliessen Sie das rote Ausgangskabel an den Pluspol der Batterie und das schwarze Kabel an den Minuspol an.
RND 305-00019 Prüfmodus und normales Laden Zunächst prüft das Ladegerät den Zustand der Batterie. Bei einer normalen Batterie erlischt die Prüfmodusanzeige nach einigen Sekunden, wonach das Ladegerät in den Lademodus schaltet. Nach vollständigem Laden der Batterie wechselt das Ladegerät in den Erhaltungs-/Wartungsmodus. Ladephasen Volllastladen: In dieser Phase wird die Batterie bis auf etwa 80 % geladen. Das Ladegerät liefert einen Maximalstrom von 5 A im Pkw-Modus und Tieftemperatur-Lademodus bzw. von 1.
RND 305-00019 Spezifikationen AC-Eingang 100 - 240 V~, 50/60 Hz, 1.5 A max. Maximaler Ausgangsladestrom 5A Max. Leistung 70 W Wirkungsgrad >78 % Maximaler Ausgangsladestrom im Niedrigtemperatur-Modus 5A Absorptionsspannung (Motorrad / Kfz-Modus) 14.4 V Absorptionsspannung (Niedrigtemperatur-Modus) 14.