User's Manual
Table Of Contents
- Important Safety Information
- Introduction
- Package Contents
- Product Overview
- Wiring Diagram
- Communication Diagram
- Preparation
- Embedding
- Wiring
- Mounting
- Activation
- Operation
- Power On/Off
- Control External Loads
- Troubleshooting
- Frequently Asked Questions
- Maintenance
- Emergency Responses
- Technical Support
- Technical Specifications
- Dimensions
21
Embedding
2. Pre-embed the RJ45 connector of the
communication cable into the installation
hole.
+
-
UP port
3. If there is only one device, connect the other end of the
communication cable to the communication port of the
specific device in use.
HUB
4. If there are multiple devices, connect the devices to Renogy
Communication Hub.
NOT
E
z
Ensure that Renogy Communication Hub is connected to the power supply.
z
The length of the communication cable connecting the device to Renogy Communication
Hub should be less than 30 meters (98.4feet).
z
If the power cable of Renogy Communication Hub is not long enough, it can be extended
according to the 12V power cable extension method in Prepare. The length of the extension
cable should not exceed 10 meters (32.8 feet).
12V Power Cable Communication Cables External Load