User's Manual
Table Of Contents
- Important Safety Information
- Introduction
- Package Contents
- Product Overview
- Wiring Diagram
- Communication Diagram
- Preparation
- Embedding
- Wiring
- Mounting
- Activation
- Operation
- Power On/Off
- Control External Loads
- Troubleshooting
- Frequently Asked Questions
- Maintenance
- Emergency Responses
- Technical Support
- Technical Speciļ¬cations
- Dimensions
23
Embedding
Recommended Accessories
RJ45 Plug to Bare Wires Drop
Cable
Drop Plugs Split Joint Pliers
NOT
E
z
The lengths of the Drop Cables shall not exceed 6 meters (19.6 feet), and the total length
shall not exceed 30 meters (98.4 feet).
z
Different drop sockets are used on the RV-C bus by different RV manufacturers. Please
select the Drop Plugs that match the drop sockets for the inter-device communication
connections. If unsure about the Drop Plug selection, please check with the RV
manufacturer. This user manual takes the Mini-Clamp II plug (4-pin) as an example.
z
Different Drop Plugs follow different pinouts. Please crimp the Drop Plugs on the Drop
Cables following the correct pinout. If unsure about the Drop Plug pinout, please check with
the RV manufacturer. This user manual takes the pinout of the Mini-Clamp II plug (4-Pin) as
an example.
Drop Tap
1. Measure whether the communication cable
can be connected to Renogy ONE and the
drop tap on the RV-C bus.
2. Pre-embed the RJ45 connector of the
communication cable into the installation
hole.
12V Power Cable Communication Cables External Load