User's Manual
Table Of Contents
- Important Safety Information
- Introduction
- Package Contents
- Product Overview
- Wiring Diagram
- Communication Diagram
- Preparation
- Embedding
- Wiring
- Mounting
- Activation
- Operation
- Power On/Off
- Control External Loads
- Troubleshooting
- Frequently Asked Questions
- Maintenance
- Emergency Responses
- Technical Support
- Technical Specifications
- Dimensions
32
Mounting
Mounting
1. Disassemble Panel Switch
1 and Panel Switch 3 from
Renogy ONE.
2. Put Renogy ONE on the
base, and use the Phillips
screwdriver to tighten the
4 M2 screws through the
mounting holes, so that
the Renogy ONE is fixed
on the base.
NOT
E
z
Make sure that Renogy ONE is installed securely to prevent it from falling off.
3. Align the snap on the back
of the panel switch with
the snap on the installation
position and press firmly to
complete the assembly of
Panel Switch 1 and Panel
Switch 3 on Renogy ONE.