Owner's manual

Warning!

Read the instructions completely before beginning the installation. Before tightening bolts check to make

sure that there are no obstructions such as brake, fuel or electrical lines that may be damaged. Also keep

in mind this is an aftermarket product and MAY require some minor shimming and or trimming, reaming

etc. To t properly.

IMPORTANT NOTICE

IF YOU ARE RECEIVING THIS ROAD ARMOR PRODUCT RAW/UNCOATED.

BE SURE TO INSPECT AND OR TEST FIT YOUR PRODUCT TO ENSURE PROPER FITMENT AND ADEQUATE SURFACE PREPARATION BEFORE

HAVING YOUR PRODUCT COATED, PAINTED, BED LINED, ETC.

ROAD ARMOR WILL NOT BE RESPONSIBLE FOR THE COST OF COATING YOUR UNIT IF ANY PROBLEMS WITH FIT OR FINISH ARE NOT

NOTED AND ADDRESSED PRIOR TO HAVING YOUR PRODUCT COATED.

THANK YOU

SUGGESTED LIGHTS THAT FIT THIS UNIT:

PIAA 510 - www.piaa.com - Part Numbers (5161, 5164, 5192, 5190, 5196).

PIAA 540 - Part Numers (5461,5462)

Warn 350F - www.warn.com Part Number (82410).

The 1999-2004 Superduty takes two sets of PIAA 510’s or Warn 350F’s

The 2005-2007 Superduty takes one set of Piaa 510’s and one set of Piaa 540’s

TOOLS NEEDED

-Yourself and a strong friend / bumper jack.

( Don’t worry, we’re not calling you or your friend a “tool” )

- Socket set, Ratchet & Wrenches (metric & standard)

( ... more than likely metric for your rig, cause everything’s imported these days,

and standard for your new bad ass Made in USA bumper.

Road Armor thanks you for supporting the American Economy! )

- Common Sense a Tape Measure and a bit of Patience

( And also a cold drink to celebrate afterwards )

99-07 FORD SUPERDUTY

FRONT BUMPER

PAGE 1
99-07 FORD SUPERDUTY FRONT BUMPER Warning! Read the instructions completely before beginning the installation. Before tightening bolts check to make sure that there are no obstructions such as brake, fuel or electrical lines that may be damaged. Also keep in mind this is an aftermarket product and MAY require some minor shimming and or trimming, reaming etc. To fit properly. IMPORTANT NOTICE IF YOU ARE RECEIVING THIS ROAD ARMOR PRODUCT RAW/UNCOATED.
PAGE 2
STEP 1 : Make sure you have all necessary tools and hardware. (2) Stiffener Brackets (4) Double Bolt Plates (6) 7/16 - 14 X 1.
PAGE 3
• Take the two tabs that have three nuts welded to them and place them in the same location as the tow hooks and using the six 1/2” bolts supplied. The triple nut plates are installed back after the stiffener bracket in picture 3 is put in place. Picture 2 - 3 • At this time take the two tabs that have the 1/2” bolts welded to them and place them inside the bumper. Using the supplied bolt retaining washers and a 3/4” socket press one on to each tab to hold is into place.