User's Manual

13
6. INSTALLATION PREPARATION
6.1. SITE TERRAIN REQUIREMENTS
Find an open area before installation. In principle, it is required to install and calibrate in areas with flat road,
wide vision (skyline can be seen) and lane lines. Considering the actual situation, the installation and
calibration shall be carried out at least on the flat ground. Park the vehicle horizontally. It is forbidden to
install and calibrate the device when the vehicle is in an inclined state. The specific site requirements have
the following two methods: Method 1: find a straight lane to ensure that the vision ahead is wide and the
distant skyline can be seen. Stop the vehicle in the center of the long straight horizontal lane and ensure
that the vehicle stops straight, as shown in the left figure: Method 2: find a flat open space to ensure that the
ground where the vehicle is parked is not inclined, and there is an open area of not less than 5 meters in
front of the vehicle in the installation site, which is convenient for the installation personnel to calibrate, as
shown in the right figure below
6.2. REQUIREMENTS FOR INSTALLATION PERSONNEL
Site construction personnel should be familiar with the functions and applications of products, understand
the composition and working principle of the whole system, be familiar with the internal structure and
electrical circuits of motor vehicles, and have experience in the installation and construction of common
device in vehicles. It is necessary to know the installation location in advance, the vehicle model of the
installation device, the selection of the installation location of the host and camera, and the length of various
cables required during installation, and prepare the required common auxiliary materials in advance to
ensure the smooth completion of device installation and commissioning.
6.3. V
EHICLE INFORMATION CONFIRMATION
Before the device is installed, the on-site construction personnel must confirm the electrical information of
the vehicle. This step is the basis for the division of responsibilities involved in vehicle damage (if any). The
next step of installation can only be carried out after all the following operations are checked:
Whether the vehicle can be ignited normally.