User's Manual

18
Figure 5: Installation Position
2)Anti-vibration: the device shall be installed at the place with weak vibration of the vehicle and away from the engine; If you
choose to install it on the center console of the vehicle, ensure that the device is firmly installed and that the device will not
move due to vehicle shaking during vehicle driving.
3)Heat dissipation: ensure that the device is far away from the heat source on the vehicle, and the device is installed in a
ventilated position, which is conducive to heat dissipation;
4)Moisture proof: the device should be installed in a dry and ventilated place;
5)Dust prevention: the device should be installed at a place with less dust;
6)Space: try to choose a flat position for device installation to facilitate fixation and maintenance. The installation space
should be kept at a certain distance from other objects as far as possible to facilitate air circulation and heat dissipation;
7)Electrical: keep away from electromagnetic complex environment and interference environment as far as possible;
8)Wiring: the wiring of the device shall be beautiful and concealed as far as possible to ensure that the operation console is
clean and beautiful. The harness exposed outside the cab needs to be protected by bellows, and it needs to avoid frequently
moving parts to prevent the harness from being damaged due to vibration and pulling during use. The difficulty of wiring shall
be considered during installation, and the modification of the vehicle body shall be avoided as far as possible;
9)Fixing: after the installation position of the host is determined, it needs to be fixed with screws to prevent shaking during
vehicle driving.
8.1.3.
Install SD card and SIM card
When installing SD card and SIM card, it is necessary to open the front lock for operation. The factory default is that the front
panel door lock is in the locked state. See Figure 1 and Figure 2 of this document for the device
Use the key to open the door according to the schematic diagram of the door lock.The notch of SIM card and SD card is
consistent with the notch orientation of the device schematic diagram. Insert sim card and SD card, and you can feel the
spring of the card holder when pressing. Pressing SIM card and SD card to the bottom indicates that the installation is
completed. The installation schematic diagram of SIM card and SD card is shown in the following figure 6
20° MAX