Owner manual
CHECK
OWNER S MANUAL
,
EPB Service Tool
11
Select Function
=================================== 3/5
1) Read Codes
2) Erase Codes
3) Deactivate Brake
4) Activate Brake
2). Use UP/DOWN button to select the purpose of deactivating the brake.
Deactivate Brake
Deactivate Brake
======================================
======================================
1) For Pad Change
2) For Repair
Deactivation Done!
Press any key to con.
Note: Please select the purpose of activation properly.
For Pad Change
is used to open the brakes completely for change of worn pads. If you just
intend to do repairs on the brakes other than changing the pads, please select
For Repair
. If
For Repair
is selected, the brakes will not open wide enoug h
for pad change and it isn't necessary to do the adaptation for Audi A8 either.
3). Wait a few minutes while the tool is deactivating the brakes. When they
are deactivated successfully, a
"Deactivation Done!"
message comes up:
If the tool fails to open the brake pads, a
"Deactivation Failed! Please
try again!"
message comes up.
- Verify that the ignition is ON;
- Check if the brake tool's OBD II connector is securely connected to the
vehicle's DLC;
- Check that the park brake is released;
- Turn the ignition off and turn it back on 10s later;
- Repeat the process.
If the
"Deactivation Failed!"
message does not go away, then contact
your local distributor or the manufacturer's customer service department for
assistance.