Owner manual
CHECK
OWNER S MANUAL
,
EPB Service Tool
13
Activate Brake
======================================
- Check if the brake tool's OBD II connector is securely connected to the
vehicle's DLC;
- Check that the park brake is released;
- Turn the ignition off and turn it back on 10s later;
- Repeat the process.
If the
"Activation Failed!"
message does not go away, then contact
your local distributor or the manufacturer's customer service department for
assistance.
If a
"The selected function is not supported!"
message shows on
the display,
- Check that the park brake is released;
- Repeat the process.
3). If you do wish to go to set the thickness of cali per, press
Y
button to
continue.
If you do not wish to do the adaptation of cali per at this moment, press N
button or use
UP/DOWN
button to select
NO
and then press
Y
to exit.
Activation Done!
Go to Adaptation?
YES NO
4). Use
UP/DOWN
button to enter new pad thickness, and press
Y
button to
confirm.
Adaptation
======================================
03 mm
[ ] or [ ] = Change
[N] = Exit, [Y] = Confirm
If you want to quit the setting, press
N
button and a
"Command
Cancelled!"
message comes up.
5). An
"Adaptation Done!"
message comes up on device screen indicating
the setting is performed successfully.
If the setting is not carried out successfully, an
"Adaptation Failed!"
message shows. Repeat operations above to try again.
6). Wait a few seconds or press any key to return.