Owner manual
CHECK
OWNER S MANUAL
,
EPB Service Tool
14
E. Adaptation
The Adaptation is used to enter the new calipers thickness of rear
brake calipers after changing brake discs & pads on Audi A8 cars.
1). Turn on ignition.
2). Release the park brake.
3). Open the brake completely by selecting
EPB-Audi
A8-Deactivate
Brake-For Pad Change
as instructed on Page11-12.
4). Change the pads.
5). Activate the brakes as instructed on Page 12-13.
6). Use
UP/DOWN
button to select
Adaptation
from
Select Function
menu and press
Y
button.
Select Function
===================================5/5
Adaptation
======================================
03 mm
[ ] or [ ] = Change
[N] = Exit, [Y] = Confirm
5) Adaptation
7). Wait a few seconds until following screen shows:
8). Use
UP/DOWN
button to enter new pad thickness, and press
Y
button to
confirm.
If you want to quit the setting, press
N
button and a "
Command
Cancelled!
" message comes up.
9). An
"Adaptation Done!"
message comes up on device screen indicating
the setting is performed successfully.
If the setting is not carried out successfully, an
"Adaptation Failed!"
message shows. Repeat steps above to try again.
10). Wait a few seconds or press any key to return.
11). Turn the ignition off.