Owner manual

CHECK
OWNER S MANUAL
,
EPB Service Tool
20
Select Function
=================================== 5/7
5) Change Brake Fluid
6) Inspect Brake Air
7) ECU Information
6). Use
UP/DOWN
button to select
Change Brake Fluid
from
Select
Function
menu and press
Y
button.
Important:
To complete the brake fluid change process, make sure vehicle
battery is fully charged and is in good condition. The brake tool keeps
detecting battery voltage during the whole process. Once the voltage is too
low to support the operation, a
"STOP: Voltage at control unit SBC xx.xV"
message indicating battery low comes up as below:
Change Fluid
======================================
STOP: Voltage at
control unit SBC
10.2V
If the voltage stays at a low level, the device is not able to proceed with the
service work. So stop the service by holding N button for at least 1 second,
and an
"Operation failed!"
message comes up.
7). Follow onscreen instructions to complete the first phase of operation:
- Connect filling and bleeding unit.
- Set pressure: 2.0-2.5 bar.
- Wait until the pressure has built up.
- Open bleeder screw at rear left brake cali per.
- Hold bleeder hose tig ht.
8). If you wish to move to the second phase of operation, press
Y
button as
instructed.
If you do not wish to continue the service, press N button to exit, and an
"Operation failed!"
message comes up.
You can exit the fluid change service at any phase of the operation with
N
button.
9). To complete the second phase of operation, do the following as instructed:
- Turn off filling and bleeding equi pment.