Owner manual

CHECK
OWNER S MANUAL
,
EPB Service Tool
21
- Wait until the pressure drops.
- Disconnect filling and bleeding equi pment.
10). Press
Y
button to move to next phase.
11). To complete the third phase, do the following as instructed:
- Set pressure: 0.5bar.
- Wait until the pressure has built up.
12). Press
Y
button to move to phase 4.
13). Following instructions on device screen to finish the fourth phase:
- Reduce pressure at filling and bleeding unit to 0 bar.
- Turn off filling and bleeding equi pment.
- Leave filling and bleeding unit connected.
- Wait until the pressure drops.
- If the filling and bleeding unit has a shutoff valve, close it.
- Switch on filling and bleeding unit.
14). Press
Y
button to continue with phase 5.
15). Follow onscreen instructions to finish the fifth phase.
- Set pressure: 2.0-2.5 bar.
- If present, open shutoff valve for filling and bleeding unit.
- Wait until the pressure has built up.
- Hold bleeder hose tig ht.
- The pressure at the bleeder screw is greater than 100 bar!
16). Press
Y
button to continue.
17). Follow onscreen instructions to finish the sixth phase.
- Close bleeder screw at rear rig ht brake cali per.
- Open bleeder screw at rear left brake cali per.
- Hold bleeder hose tig ht.
18). Press
Y
button to continue.
19). Follow onscreen instructions to finish the seventh phase.
- Close bleeder screw at rear left brake cali per.
- Open bleeder screw at front left brake cali per.
- Operate brake pedal at least 5 times and release again (pump).
- Stop pumping once the brake fluid flows out free of bubbles.
- Hold bleeder hose tig ht.
20). Press
Y
button to continue.