Owner manual

CHECK
OWNER S MANUAL
,
EPB Service Tool
28
Inspect Brake Air
=================================== 3/3
be within the black
range and be held
for 5s.
5. [Y] =Con. [N] =Return
Inspect Brake Air
======================================
11.8bar
0 25
Hold pressure within
black range for 5s.
22). Press
Y
button and following screen shows:
23). Actuate the pedal gently to raise the pressure to 20-24 bar and keep it
for 5s.
24). Follow onscreen instructions to complete operation of current phase:
- The fill level of wheel brake circuit HZ2 (secondary brake circuit) is in order.
- Release brake pedal.
- Checking fill status of wheel brake circuit HZ1 (primary brake circuit).
25). Press Y button or gently actuate and then release the pedal to continue,
and the device starts to communicate with the vehicle.
26) Use
UP/DOWN
button to view onscreen prompts.
Prompt screens to be continued…
Inspect Brake Air
=================================== 1/3
1. Increase brake pressure
slowly and evenly.
2. At 10 bar the brake pedal
counterforce is reduced but
Inspect Brake Air
=================================== 2/3
needs to be applied further!
3. Brake pressure must
not rise beyond the specified range!
4. Actual value should