Owner manual
CHECK
OWNER S MANUAL
,
EPB Service Tool
29
Inspect Brake Air
=================================== 3/3
be within the black
range and be held
for 5s.
5. [Y] =Con. [N] =Return
27). Press
Y
button and following screen shows:
Inspect Brake Air
======================================
23.4bar
0 25
Hold pressure within
black range for 5s.
28). Actuate the pedal gently to raise the pressure to 20-24 bar and keep it
for 5s.
29). Follow onscreen instructions to complete operation of current phase:
- The fill level of wheel brake circuit HZ1 (primary brake circuit) is in order.
- Release brake pedal.
- Brake system fill status is OK.
30). Press
Y
button or gently actuate and then release the pedal to complete
the air inspection service and following screen shows:
Inspect Brake Air
======================================
1. The test is OK.
2. No air is in brake system.
3. End of test.
If the device fails to inspect brake air, following screens come up:
Inspect Brake Air
======================================
1. Fail to inspect brake system
for air.
2. Function of SBC is not
assured.