User Manual

OWNER S MANUAL
,
OBD2 Car Scanner
20
CHECK
Review Data
========================1/5
===========================
Engine Coolant Temperature
Sensor 1 Circuit Hig h
If there is no data stored for selected item, a “Not Supported” or “Stored
No Data!” message shows on the screen.
3) Review selected data on screen
$09 1/6
P0118 Generic
5. OBD II Diagnostics
When more than one vehicle control module is detected by the scan
tool, you will be prompted to select the module where the data may be
retrieved. The most often to be selected are the Powertrain Control Module
[PCM] and Transmission Control Module [TCM].
CAUTION: Don’t connect or disconnect any test equipment with ignition
on or engine running.
1 Turn the ignition off.
2 Locate the vehicle’s 16-pin Data Link Connector (DLC).
3 Plug into the scan tool cable connector to the vehicle’s DLC.
4 Turn the ignition on. Engine can be off or running.
5 Press
ENTER
button to enter
Main Menu
. Use
UP/DOWN
scroll
button to select
Diagnostics
from the menu.
Stored Codes
Pending Codes
Freeze Frame
I/M Readiness
Vehicle Info.