TABLE OF CONTENTS IMPORTANT NOTICE Important Notice 1 Front view 2 Function descriptions 5 Settings and adjustments 7 Source feature 12 Installation Guide 16 * When connecting power and ground in a mobile video installation , insure that ACC wire is fused at the point where it is connected to the vehicle ACC wiring. Failure to do so can result in damage to the vehicleif a short circuit develops between the vehicle connection point and the mobile video product .
CONTROLS AND INDICATORS DIAGRAM (FRONT VIEW) 3
CONTROLS AND INDICATORS DIAGRAM (SIDE VIEW) FUNCTION DESCRIPTIONS 29 1 28 2 2 1 1 1:DISC indicator light 2:DVD Disc insertion slot 1:REMOTE CONTROL WINDOW 27 26 3 4 5 6 25 24 23 22 7 21 20 8 9 10 11 12 19 18 17 16 13 15 14 REMOTE CONTROL OPERATION 1 / 2 CR2025 CR2025 / Before attempting to operate your Remote Control , install the batteries as described above .
FUNCTION DESCRIPTIONS FUNCTION DESCRIPTIONS 6 7
SYSTEM SETUP SYSTEM SETUP PressSetupbutton,the main menu will be displayed on the screen In the General Setup Page, Press button to highlight this item. Press OK button to access. Press button to select the setting. Press OK button to confirm your selection. Press button to exit.
PLAYING JPG FILE SYSTEM SETUP --Preference Page-Audio Subtitle Disc Menu Parental Default ENG OFF ENG 1 2 3 4 5 6 7 8 KID SAFE G PG PG 13 PGR R NC 17 ADULT Set Parental Control --Preference Page-Audio Subtitle Disc Menu Parental Default ENG OFF ENG Reset Load Factory Setting Password Setup Page --Password Setup Page-Password Go To Password Setup Page TV Setup Page --TV Setup Page-TV SYS Search P/DK 00:36 03:43 Dir:001 Go To TV Setup Page \Ctyy\ ......
SOURCE FEATURE SOURCE FEATURE OVERHEAD DOME LIGHTS The Dome Light integrated into the F902 are controlled by a three position slide switch. Sliding the switch to the ON position will turn the lights ON. The OFF position will prevent the lights from turning ON with the vehicle interior lighting, and the auto position will allow the lights to turn ON and OFF with the vehicle interior lighting. Refer to the installation Guide for wire connections.
SPECIFICATIONS TROUBLE SHOOTING PROBLEM IR remote inoperative D isc won`t play Play starts, but then stops immediately No sound or distorted sound Can`t advance through a movie The icon( ) appears screen Picture is distorted SOLUTION 1.Verify that the batteries in the remote are fresh 2.Verify that the remote sensor eye is not obstructed. 1.Insert a disc with the label side facing up 2.Check the type of disc you put into disc tray. T his DVD only plays DVD, VCD,audio CD JPEG,MP3,MPEG4 3.
MATERIALS INCLUDED IN THIS PACKAGE: 1)9 LCD Overhead Monitor with DVD player(1 PCS) 2) 12 Pin Power / Signal harness ( 1 PCS ) 3) 2 Pin Power / Wire Harness with choke ( 1 PCS ) 4) 3 RCA jack pigtail ( 1 PCS) 5) Screw # M5*9 4PCS # TA4*9 6PCS # PB2.
GENERAL INSTALLATION APPROACH GENERAL INSTALLATION APPROACH 1)Decide upon system configuration and options that will be installed. 2)Review all manuals to become familiar with electrical requirements and hook ups 3)Decide upon mounting location of all components and method of mounting 4)Prep the vehicle by removing any interior trim necessary to gain access to vehicles wiring as well as all areas wher interconnecting wire harnesses will need to be located.
GENERAL INSTALLATION APPROACH CONNECTING THE DOME LIGHTS POSITIVE SWITCHED DOME LIGHTING To 12 pin connector on Monitor Red/black-Lamp on Black/red-Lamp common Purple/brown-Lamp Auto To constant +12vdc Factory Door ajar switch or Body Control computer 19 20 To constant +12vdc
NEGATIVE SWITCHED DOME LIGHTING To 12 pin connector Red/black-Lamp on Black/red-Lamp common Purple/brown-Lamp Auto To constant To constant Factory Door ajar switch or Body Control computer 21