Owner`s manual

Although it is not necessary, it may be more conve-
nient to attach the brake drums, fenders and wheels if
the axle is supported with three jack stands or blocks,
at a height of eight to 10 inches. Position one jack
stand or block at the end of each axle, and one under
the center arm.
If you choose to support the axle, make certain
that it cannot fall. Severe personal injury, as well as
damage to the dolly, can result if the axle falls.
1. First, attach both of the brake drum spindle hub as-
semblies (Figure 1) to the axles — the drums are labeled
“L” or “R”. Attach the “L” brake drum to the driver’s side
axle, and the “R” brake drum to the passenger side
axle.
Position each brake drum spindle hub assembly so
that the four holes align to the four holes in the axle,
with the stamped “L” or “R” at the bottom (Figure 1).
With the provided 12mm x 1.75 x 30mm bolts and
lock washers, attach the brake drums from the inside
of the hub assemblies (inset, Figure 1). Torque each
bolt to 59 ft./lbs.
The lock washers must be used, or the brake
drum spindle hub assemblies will separate from
the axle during use. Property damage, personal
injury or even death can result if the brake drum
spindle hub assemblies separate.
2. Attach the fenders — position both fenders so that
the three pre-drilled holes (Figure 2) align to the three
pre-drilled holes in the fender supports. Attach the
fenders to the bolts with the 3/8"-16 x 1¼" bolts, flat
washers (both sides) and nuts (Figure 2).
Position the bolts so that the heads of the bolts will
be facing the towed vehicle.
Torque the bolts to 33 ft./lbs.
3. Attach the green and white wires extending from
each brake drum to either of the two green wires on
the corresponding hub assembly — if necessary, trim
the wires to length. Connect the wires with the included
butt connectors, then slide the pre-attached shrink wrap
over the connection. Seal the shrink wrap with a heat
gun or similar device, then cover the exposed wires
with the included loom.
4. At both fenders, attach the electrical connectors
(Figure 3).
If the electrical connectors are not attached, the
tow dolly brake lights and taillights will not work
in tandem with those of the motorhome, which is
required by law.
Drivers behind the towed vehicle will not be
alerted when the motorhome stops or turns, which
INITIAL ASSEMBLY
Figure 2
4
Figure 1
may cause a traffic accident.
Failure to follow these instructions may cause
property damage, personal injury or even death.
continued on next page
Figure 3