Technical information

23
KIT# 521190-1
05/03/10
KS
6. Place the main receiver brace over the ends of the frame rails. On each side, replace the four bolts removed in the
previous step. Note: Figure H only shows three bolts. The fourth is below the brace.
Note: use thread lock on the bolts. Torque the bolts to the bolt torque requirements found at the end of this document.
7. Locate the existing hole on the inside edge of the frame rail on each side (Fig.I — passenger side). Place a ½" lock
washer and ½" clipped plate washer over one of the ½" x 1¾" bolts. Bolt through the existing hole on the inside edge of
the frame rail and into the rear mounting point of the main receiver brace (Fig.J — passenger side).
8. Reassemble the fascia, reversing steps 1 through 4.
Fig.H Fig.I
Fig.J Fig.K
MOUNTING BRACKET KIT
INSTALLATION INSTRUCTIONS
ROADMASTER, Inc. 6110 NE 127th Ave. Vancouver, WA 98682 1-800-669-9690 fax [phone] www.roadmasterinc.com
Fig.L
9. Trim the fascia using the red lines in Figure K as a
guide for trimming. Figure L shows the completed trim-
ming.
All illustrations and specifications contained herein are based on the latest information available at the time of publication approval.
ROADMASTER, INC. reserves the right to make changes at any time without notice in material, specification and models or to discontinue models.