Owner`s manual

ManualsBrandsRoadmaster ManualsAutomobile AccessoriesSterling All Terrain

Second vehicle kits

98100/98160 — If you switch BrakeMaster between two vehicles, install the 98100 or

the 98160 in the second vehicle. Both kits contain monitor wiring, air lines and instal-

lation hardware; the 98160 also includes a BrakeAway.

Second motorhome kits

98200/98300 — If you change motorhomes, install these components in the mo-

torhome. The 98200 is for motorhomes with air or air over hydraulic brakes; the

98300 is for motorhomes with hydraulic brakes.

900002 Brake Pressure Reducer

With the Brake Pressure Reducer, you can install Brake-

Master in a hybrid, a Hummer H3 or in any vehicle with

a full-time (‘active’) power braking system — reduced air

pressure eliminates over-braking issues.

Works in any supplemental braking system which uses

pressurized air to brake the towed vehicle.

Metric-to-Standard Brake Line Tees

Use these tees to install the BrakeMaster 9060 propor-

tioning valve in motorhomes with metric brake lines.

7923 for 10 millimeter brake lines. Fits virtually all met-

ric brake lines for this application.

7921 for 12 millimeter brake lines

BrakeMaster Accessories

Seat adaptors — 88XXX

Provide a vehicle-specific mounting

location to pin the BrakeMaster. Avail-

able for most vehicles; required on some

applications. Visit

www.roadmasterinc.

com

or scan the QR code above to see if

one is required for your vehicle.

104 Air cylinder storage bag

Protect your air cylinder when you’re

not towing. The storage bag is made of

marine-grade vinyl, with a Velcro clo-

sure, and has two carrying straps.

Approximate size: 26" w x 7½" h

Accessories for InvisiBrake,

Even Brake and the 9700

Second vehicle kits

98800 For the 9700

If you switch the 9700 between two vehicles, install this break away system, and

monitor and brake light signal wiring, in the second vehicle.

98400

For Even Brake

If you switch Even Brake between two vehicles, install this break away system,

ICX transmitter and Brake-Lite Relay in the second vehicle.

98700 For InvisiBrake reinstallation

(note: InvisiBrake is not designed to be switched between two vehicles.)

If you replace your towed vehicle, you can transfer the InvisiBrake controller and

air cylinder to the new vehicle with these components.

Second motorhome kit

98850 For InvisiBrake and the 9700

If you change motorhomes, install these components in the motorhome.

Air cylinder shaft and foot extensions

For Even Brake and the 9700

Although Even Brake and the 9700 fit most vehicles as is, in rare cases it may be

necessary to gain additional clearance over obstructions on the floor, or to extend

the reach of the air cylinder shaft to ensure a secure and stable fit.

9336/9336-3

Air cylinder shaft extensions

Extends the reach of the air cylinder shaft by either 1½ inches (part number

9336) or by 3½ inches (part number 9336-3).

9337/9337-4

Foot extensions

Allows the 9700 or Even Brake to sit up to one inch higher in the vehicle. Avail-

able singly (part number 9337) or in a four-pack (part number 9337-4).

921004-88

88-inch patch cord

If you’re using a drop

hitch, receiver extension or any accesso-

ry which extends the length of the towing

system, use this patch cord. It’s 12 inches

longer than the standard BrakeMaster

patch cord (part number 921004).

a drop

Brake

Pressure

Reducer

7923

Brake

Line Tee

9332

12-volt

outlet kit

four-foot

cord

9330

12-volt

‘Y’ adaptor

9331

12-volt

extension

cord

six-foot

cord