Car Stereo Receiver Owner's Manual

• Disconnect negative battery terminal before starting installation. Consult the vehi-

cle’s owner’s manual for proper instruction.

• The unit is designed for a 12Volt DC negative ground operation system only. Before

installing the unit, confirm that your vehicle is a 12Volt DC negative ground system.

• Be sure to connect the color coded leads according to the diagram. Incorrect con-

nections may cause the unit to malfunction or damage the vehicle’s electrical sys-

tem.

• Be sure to connect the negative (-) speaker leads to the negative (-) speaker termi-

nal. Never connect negative (-) speaker leads to chassis ground.

• The unit is only designed for use with 4 speakers. Do not combine output for use

with 2 speakers. Do not ground negative speaker leads to the chassis ground.

• Make sure all the connections are completely correct before turning on your unit.

• When replacing the fuse(s), the replacement must be of the same amperage as

shown on the fuse holder.

• Do not block vents or heater panels. Blocking them will cause heat to build up in-

side and may result in fire.

• After completing the installation and before operating the unit, reconnect the bat-

tery. Then press the (RES) button with a pointed object, such as a ball-point pen to

set the unit to its initial status.

Notes On Installation

Tools For Installation

• The 2 removal keys are supplied for removing the old unit and replacing with the

“VR500CS-BT”.

The following tools and supplies may also be needed for the installation:

TOOLS

• Phillips Screw-drivers

• Wire Stripper

• Wire Cutter

• Hammer

• Pencil

• Electrical Tape

• Electric Drill

SUPPLIES

• Machine Screws

• Crimp Connectors

• 14 Gauge Wire for Power Connections

• 14-16 Gauge Speaker Wires

The above are NOT INCLUDED with the VR500CS-BT and must be purchased seperately.