User's Manual
cable comes out of it.
.
If there are any vehicles compo-
plate and camera before drilling.
®
®
10. Once you have located the reverse light circuit
cable to prevent it from being caught on any ve-
hicle component such as the trunk hinge. Never
route the cable on the outside of the vehicle.
-
®
®
fuse holder.
2. Reinstall the in-line fuses.
5. Turn the monitor ON by pressing the ON/OFF button on the monitor.
on the monitor to correct the image.
change.
must permanently install it.
Fully tighten the license plate bolts.
+A
Mirror
A+
A+
A+
Mirror
Installation Installation
SCOTCH-LOK
®
INSTRUCTIONS
Installation
CAMERA WIRING DIAGRAM
2. Put the license plate bolts through the holes on the
the bolts through the holes on the license plate
5.
to the camera.
CAMERA INSTALLATION
You may mount the camera using the license plate’s top or bottom mounting bolts or
screws. When mounting the camera you must make sure that it’s eld of view is not
obstructed. Depending on the vehicle, you may mount the camera on the top or bottom
of the license plate. To adjust the angle that the camera is mounted to the vehicle use the
supplied wedge shaped shims.
Using an Existing Opening for Access Drilling an Access Hole
6.
Fig.1
Fig.2
Fig.3
Fig.4
Fig.5
Fig.6
TESTING THE SYSTEM
GIVE US A CALL, WE'LL HELP YOU INSTALL.
1-800-445-1797
PLEASE DO NOT RETURN PRODUCT TO STORE.
Visit us on the WEB
www.vr-3.com
For Information and Technical Assistance,
Call Toll-Free in U.S.A. and Canada.
®
®
and/or
®
®
®
®
®
3. Please include a detailed explanation of the problem you are having.
®
®
li-
®
®
the use or intended use of the product.