Operation Manual

English English
7 8
will appear.
5. Repeat the steps 3 and 4 to program up to 20 tracks in CD or 99 tracks in MP3.
6. Press PLAY/PAUSE (
II) button (10) once to start programmed playback.
7. To cancel programmed playback, press the STOP button (19) twice.
Note: During program playback, if you wish to repeat the entire programmed playback,
ANTI-SHOCK FUNCTION
• If in use, the player is likely to receive shocks or vibrations (i.e. whilst walking or in a
moving vehicle), The ANTI-SHOCK function is active to provide uninterrupted playback
when power on.
• Should the player receive shocks for more than 8 seconds continuously in CD playback
or 30 seconds in MP3 playback, the sound can mute for a very short while and will
resume once the player has stabilised from the shock.
Notes:
• The Anti-shock function will not correct the errors arising from the use of defective
scratched or dirty discs.
• IMPORTANT! During CD/MP3 playback, theANTI-SHOCK function is always ON and
this function can not be disactivated.
IMPORTANT
Since movement of the CD mechanism and the sensitive circuitry may cause interference
to a radio tuner nearby switch this unit off while operating other radio devices.
This product utilizes a laser
Danger - Invisible laser radiation when opened and interlock failed or defeated. Avoid
direct exposure to the beam.
Caution - Use of controls, adjustments, or procedures not listed in this manual may result
in hazardous radiation exposure.
AUX-IN
Source should have a 3.5mm diameter stereo plug.When Audio is connected (10), it can
be ear from
the speakers (other sources will be automatically disconnected).
Note: Specifications and the design are subject to possible modifications without notice due to
improvement.
SPECIFICATIONS
General
AUX-IN: 3.5mm stereo jack plug
CD Player
Pick Up: 3-Beam. Semiconductor Laser
Encoding: 16-Bit Linear
1. Press the P-MODE button (11) 4 times to enter the Random mode. “RAND” appears
on the display, then pressPLAY/PAUSE button (17) to start playback in Random order.
2. Press SKIP Forward button (13) to go to next Random track.
3. Press the P-MODE button repeatedly until “R
AND” disappears from the display to
return to the Normal Playback mode.
programmed. The track number which will be programmed will appears on the display.
4. Press once the PROGRAM
button (11). to enter the track into memory. “P02”
INCD
1. Press the PLAY/PAUSE button (17) and after 5 seconds the STOP button (19).
2. Press the PROGRAM button (1
2). The track number “P01” will appear and
press the P-MODE button (11) repeatedly until the indicator appears
inthe display.
PROGRAMMED PLAYBACK FOR CD/USB
RANDOM PLAY WITH CD / USB
“P” will appear on the display indicating the first selection.
3. Press SKIP Back () or SKIP Forward () button to select the desired track to be
()
()
HEADPHONE OUTPUT
Use this output (22) to connect an Headphone.
Set the Funtion Selector (9) to CD/MP3/USB/AUX position.
Power Supply
To select a song/track which number exceeds 10, press the FOLDER/10+ button
each time to skip forward 10 tracks, then press the button to select desired track.
To select a desired folder, press and hold the FOLDER/10+ button each time to skip
forward a folder, then press the
button to select desired track.
(18) FOLDER + / +10 and FOLDER - / - 10 FUNCTION
AC: 230V ~ 50Hz
Batteries: 6 x UM-2
Radio Frequency CoverageFM: 87.5 -
108 MHz