Operation Manual

English English

POWER SUPPLY

This unit operates from a main supply of 230V ~ 50Hz. Connect the AC

power cord to the AC household main outlet. Ensure that the voltage

is as indicated on the rating plate on the rear of the unit.

Battery Back-up Power Failure Protection

This radio has a battery back up circuit that will keep the correct time

and alarm settings in the event of a temporary power interruption.

Install a 9-volt battery (type 6F 22/006P), not included, into the battery

compartment located on the bottom of the unit.

Note: We recommend an alkaline battery for longer usable life.

Change the battery every 9 to 12 months for best result and avoid

possible battery leakage.

If power is temporarily interrupted the display will blink and the radio

will not play. However, the battery back-up circuit will continue to

maintain the clock and alarm settings. When power is restored the clock

will display the correct time and alarm settings, and no adjustment is

necessary.

Note: If power is interrupted and there is no battery in the compartment

or the battery is exhausted. The time and alarm settings will be

lost. When power is restored the clock will begin to flash

indicating that the time and alarm settings must be corrected.

SETTING THE CORRECT TIME

1. Press and hold the TIME Button (7).

2. Press HOUR button (3) to advance hour

3. Press MINUTE button (4) until the correct time is displayed.

4. Release the TIME Button (7).

SETTING THE WAKE UP TIME

1. Set the FUNCTION Selector (12) to the OFF position.

2. Set the alarm time by following this procedure:

3. Press and hold the ALARM Button (6).

4. Press the HOUR Button (3) to advance hour press MINUTE Button

(4) until the desired alarm time is displayed.

5. Release the ALARM Button (6).

6. To check the correct alarm time is set, press the ALARM Button (6).

WAKE TO BUZZER ALARM

1. Set the alarm time as shown above.

2. Set the Function Selector (12) to the AUTO position.

The ALARM ON “” indicator will light up on the top left

side of the display. Turn Off the Volume control until you

hear a “click” (Buzzer).

3. To switch off the alarm either press the AL. OFF Button (2), or

set the FUNCTION Selector (12) to the OFF position.