Operation Manual

English English

SNOOZE FUNCTION

When the alarm sounds, pressing the SNOOZE Button (1) will temporary

stop about 9 minutes then the alarm sounds again.

SLEEP FUNCTION

1. This function enables you to go to sleep listening to the Radio.

2. Set the FUNCTION Selector (12) to OFF or AUTO.

3. Press the SLEEP Button (5). The clock display will show 59 minutes.

The Radio turns on and will turn off automatically after 59 minutes.

4. To select a shorter time press the MINUTE Button (4) while holding

the SLEEP Button (5) until the desired sleep time is displayed.

5. To turn off the Radio at any time during the Sleep period, press

the SNOOZE Button (1).

CARE AND MAINTENANCE

To prevent fire or shock hazard, do not allow this clock radio to be

exposed to rain or moisture.

This clock radio should not be exposed to direct sunlight, very high or

low temperature, moisture, vibration, or placed in a dusty environment.

Do not use abrasives, benzine, thinners, or other solvents to clean the

surfaces of the clock radio. To clean it, wipe with a mild non-abrasive

defergent solution on a clean soft cloth.

Never attempt to insert wires, pins, or other objects into the venlilation

WAKE TO THE RADIO

1. Set the alarm time as shown above.

2. Set the Band Selector (10) to the desired radio band, and follow

the procedure in LISTENING TO THE RADIO to tune the radio to

a station.

3. Set the VOLUME Control (15) to a level you feel will wake you.

4. Set the FUNCTION Selector (12) to the AUTO position. ALARM

ON “” indicator will light up on the bottom left side of the

display.

5. To switch off the alarm either press the AL. OFF Button (2) or set

the FUNCTION Selector (12) to the OFF position.

LISTENING TO THE RADIO

1. Set the FUNCTION Selector (12) to the ON position.

2. Set the BAND Selector (10) to the desired band (FM or MW).

3. Turn the TUNING Knob (16) until the desired station is heard.

4. Adjust the VOLUME Control (15) to a comfortable listening level.

5. To turn off the radio, set the Function Selector (12) to the OFF

position.

Note: For FM reception there is a built-in FM antenna wire at the rear

of the unit. Move the wire around to obtain the best reception.

The AM band uses a built in directional aerial. You may have

to rotate the clock radio for the best reception.