Instruction manual

HDMI Through
Default Value: Off
Enable or disable "Auto Standby" while "HDMI Through" is on.
"On": The setting will be enabled.
"Off": The setting will be disabled.
The setting cannot be changed, if "Auto Standby" is set to "Off".
When "HDMI Through" is used, the power consumption increases even
when the unit is on standby. However, the increase in power consumption
is kept to a minimum by automatically entering the HYBRID STANDBY
mode, where only the essential circuit is operating.
Network
Make the network setting.
When LAN is configured with a DHCP, set "DHCP" to "Enable" to
configure the setting automatically. ("Enable" is set by default) To assign
fixed IP addresses to each components, you must set "DHCP" to
"Disable" and assign an address to this unit in "IP Address" as well as set
information related to your LAN, such as Subnet Mask and Gateway.
Network Standby
Default Value: Off
You can turn on the power of the unit via network using an application
such as Onkyo Remote.
"On": Use this function
"Off": Do not use this function
When "Network Standby" is used, the power consumption increases
even when the unit is on standby. However, the increase in power
consumption is kept to a minimum by automatically entering the
HYBRID STANDBY mode, where only the essential circuit is
operating.
Wi-Fi
Default Value: Off(Wired)
Connect the unit to network via wireless LAN router.
"On": Wireless LAN connection
"Off(Wired)": Wired LAN connection
Wi-Fi Setup