Instruction manual

Assigning Another Device's Remote Controller
Functions to the Unit's Remote Controller
If you want to add some functions after registering a remote control code to
the REMOTE MODE button, you can assign the desired button of the unit's
remote controller to learn the functions of another device's remote controller.
You can assign only one function in one procedure.
1. While holding down the REMOTE MODE button to which you
programmed the remote control code of the other device to be learned,
press and hold RECEIVER about 3 seconds until the REMOTE MODE
button stays lit.
2. Press the desired button of the unit's remote controller that you want to
assign.
The RECEIVER, ZONE, ACTIVITIES, REMOTE MODE/INPUT
SELECTOR, and REMOTE (MODE, TV, RECEIVER) buttons cannot
learn functions:
3. Face the remote control sensor of the other device with that of the unit
and put the remote controllers within 10 cm from each other.
4. On the other device's remote controller faced to the unit's remote
Operating Other Components with the Remote
Controller