Instruction manual

Assigning the desired operation to an ACTIVITIES button
You can assign an operation sequence to the desired ACTIVITIES button.
For example, if you play the CD player connected to the unit using the
remote controller, the following button operations are normally necessary.
1.Press RECEIVER to turn the remote controller into the RECEIVER
mode.
2.Press RECEIVER to turn on the unit.
3.Press TV/CD to switch the unit's input to TV/CD.
4.Press to start playing on the CD player.
If you assign these steps with the procedure below, you can execute them
by simply pressing a button. You can assign up to 32 steps in one
procedure.
1. While holding down RECEIVER, press the desired ACTIVITIES button
(MY MOVIE, MY TV or MY MUSIC) about 3 seconds until the
ACTIVITIES button (MY MOVIE, MY TV or MY MUSIC) stays lit.
2. Press the buttons to be used in order of their sequence.
Example: Playing CD
1.Press RECEIVER.
2.Press TV/CD.
3.Press .
3. Press the ACTIVITIES button (MY MOVIE, MY TV or MY MUSIC) you
pressed in step 1 again.
Assignment is complete when the ACTIVITIES button flashes twice.
After assignment of the ACTIVITIES button is completed, malfunction
may occur if you overwrite a button included in its operation sequence
with any other operation.
4. To execute the learned operation, press the desired ACTIVITIES button.
To clear the learned operation:
1. While holding down HOME, press ALL OFF about 3 seconds until the
ALL OFF button stays lit.