Instruction manual

RI Connection and Setting
Connect an Onkyo component with RI jack to this unit using an RI cable and
an analog audio (RCA) cable. For details, refer to the instruction manual of
the component with RI jack. The RI cable can be connected in any order.
When there are two RI jacks, both jacks work in the same way and are
interchangeable.
To connect the RI Dock or cassette tape deck via RI, you must:
Rename the input selector
To make the RI functions work, you must rename the input selectors on the
unit. Press TV/CD or GAME to display "TV/CD" or "GAME" on the main unit
display. Then press and hold TV/CD or GAME 3 seconds or more to switch
the display to "DOCK" or "TAPE".
Program the RI remote control code
Program the remote control code to any REMOTE MODE button on the
remote controller. This will allow you to operate the component by pointing
the remote controller at the unit instead of the component.
1. Press DISPLAY for 3 or more seconds while holding down the REMOTE
MODE button to which you want to program the remote control code.
The REMOTE MODE button stays lit.
Connecting and Operating Onkyo RI Components