Instruction manual

Updating the Firmware via USB
Before Start:
Prepare a 64 MB or larger USB storage device.
– Media inserted in a USB card reader may not be used for this function.
– USB storage devices with security function are not supported.
– USB hubs and USB devices with hub function are not supported. Do
not connect these devices to the unit.
Delete any data stored on the USB storage device.
Turn off the controller component (PC etc.) connected to the network.
Stop any playing Internet radio, USB storage device, or server content.
If the multi-zone function is active, press OFF on the main unit to turn it
off.
If "HDMI CEC (RIHD)" is set to "On", set it to "Off" (default value).
– After pressing RECEIVER, press HOME on the remote controller.
Select "Setup" with the cursors and press ENTER. Then, after
selecting "7. Hardware Setup" - "HDMI" and pressing ENTER, select
"HDMI CEC (RIHD)" to select "Off".
＊ Some USB storage devices may take long to load, may not be loaded
correctly, or may not be correctly fed depending on the device or their
content.
＊ Onkyo will not be liable whatsoever for any loss or damage of data, or
storage failure arising from the use of the USB storage device with this
AV receiver. Thank you for your understanding.
＊ The description may differ from the on-screen display but that will not
change the way to operate or the function.
Update
1. Connect the USB storage device to your PC.
2. Download the firmware file from the Onkyo website to your PC and unzip.
Firmware files are named in the following way:
ONKAVR＊＊＊＊_＊＊＊＊＊＊＊＊＊＊＊＊.zip
Unzip the file on your PC. The number of unzipped files and folders
varies depending on the model.
3. Copy all unzipped files and folders to the root folder of the USB storage
device.
Make sure to copy the unzipped files.
4. Press USB on the remote controller to select "USB".
Firmware Update