Instruction manual

Resetting the unit
Resetting the unit to the status at the time of shipment may solve the
problem. If the measures above do not solve the problem, reset the unit with
the following procedure. If you reset the unit status, your preferences will be
reset to the defaults. Note them down before starting reset.
How to reset
1. While holding down CBL/SAT on the main unit (note that step 2 must be
performed with this button pressed down)
2. Press ON/STANDBY on the unit. “Clear” is appeared on the display and
the unit will enter standby mode.
How to reset the remote controller
1. While holding down 1 RECEIVER on the remote controller (note that
step 2 must be performed with this button pressed down)
2. Press and hold down 2 HOME until the 1 RECEIVER button lights
(about 3 seconds). Within 30 seconds, press 1 RECEIVER again.
Troubleshooting