Instruction manual

Wi-Fi (Wireless LAN) Network
Cannot access to Wi-Fi (Wireless LAN) network or sound playback is
interrupted and communication does not work
Try plugging/unplugging the power supply of wireless LAN router and the
unit, check the wireless LAN router power-on status, and try reboot of the
wireless LAN router.
The setting of SSID and encryption (WEP, etc.) is not correct. Make sure
the network settings of the unit is properly set.
Connection to an SSID that includes multi-byte characters is not
supported. Name the SSID of the wireless LAN router using single-byte
alphanumeric characters only and try again.
Cannot receive radio wave due to a bad connection. Shorten the distance
from wireless LAN access point or remove obstacles for a good visibility,
and try again. Place the unit away from microwave ovens or other access
points. 2.4 GHz band for wireless LAN may not be enough. Connect
ETHERNET terminal of the unit and the router via an Ethernet cable after
selecting "7. Hardware Setup" - "Network" and changing "Wi-Fi" to
"Off(Wired)".
Place the unit away from the components emitting electromagnetic waves
on the 2.4 GHz band (microwave ovens, game consoles, etc.). If this
does not solve the problem, stop using other components which emit
electromagnetic waves.
When other wireless LAN devices are used near the unit, several issues
such as interrupted playback and communication may occur. You can
avoid these issues by changing the channel of your wireless LAN router.
For instructions on changing channels, see the instruction manual
provided with your wireless LAN router.
If there is a metallic object near the unit, wireless LAN connection may
not be possible as the metal can effect on the radio wave.
If there is more than one access point in the network, separate each
access point.
It is recommended to place the Wi-Fi router (access point) and the unit in
the same room.
The connection does not complete even when the automatic setting
button is pressed on the wireless LAN router
The wireless LAN router setting may be switched to Manual. Return the
setting to Auto.
Try the manual set-up. The connection may succeed.
Troubleshooting